z-engineering charger info... can someone print

[USOPHUNKE]

http://philhalbasch.com/charger/MK3_VR6_FITTING.pdf


if someone could print this out for me it would be great. I need it to install my charger.

Brent

[vwremglx]

I didn't have any directions and neither should you! :rofl:

[boostin20v]

Do you need it rehosted so you can print it or do you really need a hard copy made?

[RichB]

Done... have a copy here for you Brent. Just LMK if you want to drop by to get it or when I can hand it to you.

[USOPHUNKE]

Done... have a copy here for you Brent. Just LMK if you want to drop by to get it or when I can hand it to you.

thanks Rich. I will give you a call when I can grab it. I am not in a huge rush I just really didnt want it to disappear as it was one of the only good info things I have found.

[USOPHUNKE]

found this too which I may need to fig out my schrick issues.. love them northern beer makers

http://www.corrado-club.ca/mods/schrick.html

[RichB]

thanks Rich. I will give you a call when I can grab it. I am not in a huge rush .

OK... no prob. :ssmile: